Oxilife Sugar Valley - Hydrolysis Salt Chlorinator low salinity

Oxilife Sugar Valley – Salt Chlorinator low salinity hydrolysis

Oxilife is a water disinfection system that uses two methods without the need to add chemicals.

The first is hydrolysis, which breaks the water molecule into hydrogen and oxygen, generating oxygen-based disinfecting agents such as O3, O2, OH-, H2O2, among others.

The second method is low-salinity Salt Electrolysis, where residual chlorine is generated from the salt present in the water. These combined methods make it possible to achieve effective water sterilization without additional chemicals.

The Oxilife low salt chlorinator and hydrolysis equipment guarantees the elimination of bacteria, fungi and other impurities that threaten your health through the two processes, without using auxiliary chemical products.

Thanks to its included temperature probe, the Oxilife can perform chlorination in “smart” mode, adapting the disinfectant production to the needs of the pool.

The Oxilife system also allows a complete management of the pool from a single device, since it allows to control and automate the pH level and redox from the same device.

Finally, the Oxilife Low Salt chlorinator allows remote control via WIFI or Ethernet, through the free Poolwatch application, or by connecting the device to automatons with modbus protocol.

This low salinity salt chlorination model comes in two versions with different Control boxes: for residential pools (models OX0, OX1, OX2 and OX3) and for Commercial Pools (models OX4, OX5, OX6, OX7, OX8 and OX9) and can operate in sizes from 20 to 750 cubic meters.

The pH pump is not working, and an AL3 signal appears on Oxilife. What’s going on?

The Hayward Aquarite + Touch and the Hidrolife Touch have a pH reducer over-dosing control function. When the unit detects that the dosing pump has been running for too long, it activates the AL3 alarm and stops the pH dosing pump. To restart it, check that the bottle has product in it, check that the pH measuring probe is in good condition and, once you are sure that the system is correct, press for 3 seconds on the pH circle to remove the AL3 alarm.