Modul'Eau - Water level regulator for swimming pools

Thanks to its advanced electronic system, this equipment periodically monitors the water level in the pool or tank and, when it detects that it is below the set point, it triggers the opening of a solenoid valve to automatically replenish the level.

Thanks to its characteristics, it can be installed in both existing and new pools, as it does not require breaking the skimmer or previous installation during the construction phase.

The height of the water is regulated according to the position in which the probe is installed in the pool, basin, surge tank or basin. If the probe is no longer in contact with the water at the time of testing, the MODUL’EAU® itself starts filling without the need for manual intervention.

In addition, it incorporates a filling cut-off safety function, configurable according to the needs of the installation.

As an additional protection, the equipment also monitors the opening time of the solenoid valve: if this exceeds the programmed safety limit, the valve closes immediately and the red fault light is activated , thus preventing overfilling by mistake .

Safety and water level control

The Modul Eau incorporates a programmable safety system to prevent overfilling or water waste. A maximum filling time can be set in 30-minute intervals, from 30 minutes to 7.5 hours.

If the solenoid valve remains open beyond the programmed time, the system will automatically close it and a visual alert with an anomaly indicator light will be activated.

Intuitive and easy-to-use control panel

The Modul Eau has a control panel with indicator lights that allow you to monitor its status at a glance:

• Anomaly indicator: It lights up when the system detects a problem and stops filling.
• Solenoid valve active indicator: Confirms that the solenoid valve is in operation.
• Power indicator: Shows that the system is operational and receiving power supply.
• Proper level indicator: Illuminates when the probe is submerged again and the water level is correct.

Technical specifications of the Modul Eau automatic pool water level regulator

• Dimensions: 175 mm (height) x 205 mm (width) x 85 mm (depth)
• Protection: IP56 (dust and splash water resistant)
• Power supply: 240 V / 50 Hz
• Consumption: 5 W
• Output for solenoid valve: 24 V / 230 mA max.
• Probe dimensions: 70 mm (height) x 12 mm (width) x 10 mm (depth)
• Probe cable: 2 meters, extendable up to 20 meters – (not included)

Modul Eau kit contents

• 1 electronic control module with visualization of the various functions
• 1 electronic probe with 2 meters of cable
• 1 fixing kit and spare fuses

Remarks

– Filling solenoid valve not included.